MemberMay 16, 2016 at 5:28 pm
Why didn’t you say that it had been moved from a hinge track in the first place instead of asking for parts – we don’t bite! much
It just needs reprogramming, if it has come off a hinged track then it is looking for the hinge enabled signal.
Move the lift off of a charge point. Turn it off put a link in on the receiver board across the two pins, then turn on go to each remote and press for three seconds.
Turn off then remove link and test – board should be programmed for non hinge setup.
The Stairlift Forum
Find answers, ask questions, and connect with our
community around the world.