-
Error Flow2a
updated 1 year, 1 month ago
2 Members
·
6
Posts
-
Hello,
I have an error on a flow2a after rail change.
I reset the rail data (mode 9) but I have a code F52 and beeps.
I can switch to mode 3 and move my engine but still this code F72.
I failed to reset the counter because I don’t have an installation joystick.
How can I do without it?
Thank you
Laurent -
F52 is the charger on and correctly polarised? -ve to top strip on all but the first charge points.
Have you set it to Mode 3 and taken it down to the first charge point till you see RST?
Have you restored or programmed rail data into the carriage?
F72 should be cleared by pulling joystick out of the UI and refitting.-
Hello,
Thanks for the answer.
I had not reversed the bottom contacts, I modified. Now I have a RST by going down in mode 3.
I no longer have an F52 but an F53. I removed the joystick and put it back on but it doesn’t change anything.
Thank you
Laurent
-
-
F53 is swivel position unknown, do you have manual or auto swivel?
Check mode 9 that it is set to the correct option SA or SN for auto or none.
Mode 4 or 5 can’t remember which one does swivel position and one does level. Make sure it’s centered in that one if auto.
-
Thank you so much for your help.
I was able to cancel the F53 code. It was in SA but it must have had a validation problem.
I was able to reprogram my rail with the SD card.
This works well with RF remote controls but not with the UI user interface (cabled model).
It lights up red and nothing happens.
I recorded it in mode 7 as the RF remotes but I have nothing defin in mode 8 for the UI.
In mode several symbols are unknown to me: Err, Cer, Fsd, Bra Up9 and Anr.
Thanks again.Laurent
-
-
Hello,
I solved my red UI problem!
You only had to fasten the belt because there is a detection.
Is it possible to disable it by programming?Thank you Kevin.
Laurent
Viewing 1 - 4 of 4 replies