MemberAugust 31, 2017 at 8:42 pm
As I was installing the body of the stairlift on the upstairs rail, a duel copper gear moved in a way that made me think that maybe I didn’t install it correctly. The copper colored gear is about 1/3 of a gear attached to a white wheel. The white wheel is on the outside side of the rail. I have attached a picture. This may be too difficult of a problem to solve on a forum but I thought that I would give it a shot. Thank you for your help.
MemberSeptember 1, 2017 at 3:56 pm
You have triggered the osg mate. I have sent you an email with the requested Manuals
MemberSeptember 25, 2017 at 3:18 pm
The zero code or “O” code means that there is a problem with the overspeed governor. The overspeed governor is on the back of the stairlift carriage and can be accessed by removing the covers. It sits in between the drive motor and the leveling motor. The purpose of the OSG is to stop the stairlift in the event that the stairlift is going to fast. The overspeed governor is like a mouse trap that needs to be set and can easily be tripped causing this error code. You can manually reset it by pressing a black tab at the back of the lift and making sure the plunger switch is held open by the white plastic tab on the plastic ring.
Log in to reply.