News Feed › Forums › Stairlifts › Acorn 180 Installation Manual
-
Acorn 180 Installation Manual
-
Does anyone have an Acorn 180 installation manual?
-
-
I just purchased a used Acorn 180 stairlift for my Mother. Could you send the installation manual? I was told there was programing that needed to be done but hope I can do so myself and safe the $1100 installation charge.
Thank you.
-
-
sorry guys been away on hols. I will send to those who inboxed me their email addys
-
Really hope to get this manual.
I have 2 horizontals lines on the display -
Hi ianb , I’ll appreciate if you would send me this installation manual as well .
-
If you don’t have the manual, this is somewhere to start: http://okprops.com/how-to-problem-solve-an-acorn-180-or-bison-80-stairlift/
-
Thank you Okmobility , I already recorded it .I got an error code small ”o” at regular intervals when the chair is going up . It’s not a big “0” as if the osg was faulty So i wonder if the installation manual would writed about it..
-
That error code means that the overspeed governor isn’t rotating. Message me your email address and I can send you the manual.
-
The error code means the rotation of the osg is not being picked up by the optical sensor. a couple of possibilities. As above post states or faulty sensor(check the 3 wires onto the sensor board are intact) and the sensor position is seeing the flag going in and out if the osg is rotating
-
Hello,
I have an Acorn 180 curved rail, second hand, just installed for my mother. When powered up I got F7 code for the overspeed relay trip. Per instructions I manually moved it up but it did not reset. If the switch is bad where could i find a replacement?
Thank you much for support